產品詳情
| 牌號 | 1.0122易切削 光面鋼 |
| 對應標準 |
ISO 683-18-2014 熱處理鋼、合金鋼和易切削鋼 -- 第18部分：光面鋼制品 Bright steel products |
| 歸類 | 合金鋼 |
1.0122化學元素成分含量(%)
| 成分 | C | Mn | P | S ① | Cu ③ | N ② | |
|---|---|---|---|---|---|---|---|
| t≤40mm | 最小值 | - | - | - | - | - | - |
| 最大值 | 0.17 | 1.4 | 0.04 | 0.04 | 0.55 | 0.012 |
| 成分 | C | Mn | P | S ① | Cu ③ | N ② | |
|---|---|---|---|---|---|---|---|
| 40mm＜t≤100mm | 最小值 | - | - | - | - | - | - |
| 最大值 | 0.2 | 1.4 | 0.04 | 0.04 | 0.55 | 0.012 |
① For long products. the max. S content may be increased for improved machinablility ba 0,005 % by agreement if the steel is treated to modify the sulphide morphology and if the chemical comb shows min 0,0020 % Ca.
② The maximum value for nitrogen does not apply if the chemical comb shows a minimum total Al content of 0,020 % or, alternalively, minimum 0,015 % acid soluble Al or if s ufficient other N-binding elements are present. In this case, the N-binding elements shall be mentioned in the inspection document.
③ Cu contenl above 0,40 % can cause hot shortness during hot bing.
② The maximum value for nitrogen does not apply if the chemical comb shows a minimum total Al content of 0,020 % or, alternalively, minimum 0,015 % acid soluble Al or if s ufficient other N-binding elements are present. In this case, the N-binding elements shall be mentioned in the inspection document.
③ Cu contenl above 0,40 % can cause hot shortness during hot bing.
1.0122機械性能
|
厚度 t mm |
熱處理或狀態 |
抗拉強度 σb Mpa |
屈服點 σs Mpa |
斷后伸長率或延伸率 δ % |
硬度 HBW |
|---|---|---|---|---|---|
| 5≤t≤10 | Cold drawn (+C) | 470~840 | ≥355 | ≥8 | |
| 10＜t≤16 | Cold drawn (+C) | 420~770 | ≥300 | ≥9 | |
| 16＜t≤40 | Cold drawn (+C) | 390~730 | ≥260 | ≥10 | |
| 40＜t≤63 | Cold drawn (+C) | 380~670 | ≥235 | ≥11 | |
| 63＜t≤100 | Cold drawn (+C) | 360~640 | ≥215 | ≥11 | |
| 16＜t≤100 | As-rolled + peeled (+SH) | 360~510 | 107~152 |
